NOTICE
b
Do not use aggressive or abrasive cleaning agents.
b
Do not use chemical de-icing agents (e.g. de-icing spray, glycol).
b
Recommendation: Use anti-static cleaning agents.
b
Recommendation: Use anti-static plastic cleaners and lens cloths from SICK.
Approach
Cleaning the optics cover
1.
Remove dust from the optics cover using a soft, clean brush.
2.
Moisten a clean, soft towel with anti-static plastic cleaner and use it to wipe the
optics cover.
3.
Check the effectiveness of the protective device,
principal function of the protective device", page 59
.
Cleaning the field of view
b
Remove any objects or animals (e.g., insects) from the area in front of the optics
cover, e.g., in the weather hood or other cladding.
Complementary information
NOTE
The display shows a contamination warning if the optics cover is contaminated and
needs to be cleaned soon. If it is not cleaned and the contamination continues to
increase, the safety laser scanner switches to the OFF state for safety reasons and the
display shows a contamination error.
b
Check the optics cover for damage.
b
Clean the optics cover in a timely manner.
Further topics
•
•
10.3
Replacing the optics cover
If the optics cover is scratched or damaged, it must be replaced.
Your SICK subsidiary will replace the optics cover for you.
10.4
Replacing the safety laser scanner
If the safety laser scanner is damaged or defective, you must replace it.
DANGER
Hazard due to lack of effectiveness of the protective device
If an unsuitable configuration is saved in the system plug, it may cause the dangerous
state to not end in time.
b
After replacement, make sure the same system plug is used or the configuration is
restored.
b
Make sure that the safety laser scanner is aligned correctly after the replacement.
MAINTENANCE
10
8023152/1G5N/2022-06-28 | SICK
O P E R A T I N G I N S T R U C T I O N S | outdoorScan3 Core I/O
117
Subject to change without notice