7
MAINTENANCE
142
8020776/12AX / 2019-05-31|SICK
O P E R A T I N G I N S T R U C T I O N S | Free Flow Profiler
Subject to change without notice
7.3.4
Updating the measurement site
After replacing a system component, you will have to update the measurement site using
TEMS Manager in order to guarantee continued measurement accuracy.
The procedure you should follow depends on whether you have replaced a sensor or the
Traffic Controller FPS.
Requirements
•
Using the installed TEMS Manager program, you have connected to the Traffic
Controller FPS via the
Ethernet 1
TCP/IP interface (see chapter
•
The
site configuration
has been
stored
on a backup data card.
7.3.4.1
Updating after replacing a sensor
In this case, the Traffic Controller FPS is not affected by the component replacement and
so you can update the configuration that is currently running on the TEMS Recorder.
Establishing a connection with the TEMS Recorder
1. Connect to TEMS Manager.
2. In TEMS Manager, log in as a user with the
Authorized User
authorization or higher.
Stopping the current configuration
1. Click the
Stop current site configuration / Exit editing mode
icon.
2. Switch to editing mode. To do this, click the
Edit site configuration
icon.
