B06 20 243 E-EN
page 4 / 23
09.2010
Installation and Maintenance Manual
CB8-E
Work on the brake may only be performed while it is stationary. The drive unit must be secured
against inadvertent switch-on (e.g. by locking of the key switch or by removing the fuses in the
power supply). At the switch-on point, a warning sign must be put up indicating that work is in
progress on the brake.
The drive unit must be stopped immediately if changes are detected in the brake during
operation, for example changes in operating noise.
The brake must be safeguarded against inadvertent contact by appropriate safety guards.
Before installation of the brake inside equipment or facilities, the manufacturers of the latter are
under an obligation to incorporate the regulations, directions and descriptions contained in these
operating instructions into their own operating instructions.
Any work carried out on the brake, which is not mentioned in this manual, should be regarded as
repair. In such cases, please contact your local SIBRE supplier.
2.2 Symbols used in the operating instructions
The important instructions contained in the operating instructions and relating to both safety and
protection are highlighted as follows:
WARNING
This symbol indicates safety measures that must be followed without fail to prevent injuries.
CAUTION
This symbol indicates safety measures that must be followed without fail to prevent damages.
PLEASE NOTE
This instruction refers to general operating directions which must be particularly noted.
