46
Troubleshooting
TROUBLESHOOTING
Solo/Pro 2 is 100% programmed and tested at the
factory. In case of a malfunction please use the
troubleshooting guide table.
Possible Cause Solution
Symptom
Screen
won't run
Check for 120V at
power connection and/
check breaker box.
Material has
shifted at the
weight bar
An intermediate
stop was set for
the motor
Gently move the
material out to each
end of the weight bar
until smooth.
Call SI Customer
Support to fix at
512.832.6939, Opt. 1
No power to the
motor.
Vertical
wrinkles in
screen
When down
button is
pressed,
screen stops
halfway
Dimples in
screen
Debris rolled up
in screen material
Clean material per
instructions on Pg 31.
