Si-tex SP38, Installation And Operation Manual, Page: 57 / 193

Sitex SP38 Installation and Operation
Document PN 29010101 V1r0
- 57 -
Compasses
All compasses, other than NMEA 0183 compasses, are connected to the SPU receptacle
labelled
J9 – C
OMPASS
(see the Compass section for how to connect NMEA compasses).
If you ordered your SP38 system with a Sitex Fluxgate Compass, the cable wires connect to
the
J9 receptacle, as per the diagram in Figure 30 .
If you ordered your system with the Magnetic Sensor, and mounted it on the bottom of your
magnetic compass, you will also need to wire the flying-lead end of the sensor cable as per the
diagram in
Figure 30 . If you mounted the sensor of top of the compass, simply exchange the
blue and yellow wires.
Figure 30 – Wiring Connections for Analog Compasses
Rudder Follower
The Rudder Follower is connected to the four-position receptacle on the SPU labelled
J4 – R
UDDER
F
OLLOWER
. Wire the Rudder Follower to the plug-in connector as per the following
diagram in Figure 31 .
Figure 31 – Wiring Connections for Rudder Followers