- 14 -
Step 2.
Set Jumpers
This mainboard is jumperless! The default jumper settings have been set for
the common usage standard of this mainboard. Therefore, you do not need
to reset the jumpers unless you require special adjustments as any of the
following cases:
1. Clear CMOS
2. USB Power-On
3. BIOS Write Protection
4. Enable/Disable LAN (MS50N only)
For first-time DIY system builders, we recommend that you do not change the
default jumper settings if you are not totally familiar with the mainboard
configuration procedures. The factory-set default settings are tuned for opti-
mum system performance. For the advanced users who wish to customize
their system, section
3.2 Jumper Settings
will provide detailed information on
how to configure your mainboard manually.
Step 3
Install SDR SDRAM System Memory
To install memory, insert SDR SDRAM memory module(s) in DIMM slot(s).
Note that SDR SDRAM modules are directional and will not go in the DIMM
slots unless properly oriented. After the module is fully inserted into the
DIMM slots, lift the clips of both sides of the DIMM slot to lock the module in
place.
