- 37 -
#$
#$
#$
#$
#$
Other Connectors
ATX Power Supply Connector (JP13)
Locate the 20-pin male header ATX power connector (JP13) on your
mainboard. Plug the power cable from the ATX power supply unit directly
into (JP13) ATX power supply connector.
Note 1:
The ATX power connector is directional and will not go in unless the
guides match perfectly making sure that pin#1 is properly positioned.
Note 2:
Make sure the latch of the ATX power connector clicks into place to
ensure a solid attachment.
Note 3:
Your ATX power supply must be supplied to ACPI +5V standby power
and at least 720mA compatible.
Note 4:
Make sure your power supply have enough power for higher speed
processor installed.
Cooling Fan Connectors for CPU (FAN1), Chassis (FAN2), AGP (FAN3),
and North Bridge ( FAN4) Fan
The mainboard provides four onboard 12V cooling fan power connectors to
support CPU FAN (FAN1), Chassis (FAN2), AGP Card (FAN3), and North
Bridge (FAN4) cooling fans.
E1
E2
Note:
Both cable wiring and type of plug may
vary depending on the fan maker. Keep
in mind that the red wire should always
be connected to the +12V header, and
the black wire, to the ground (GND)
header.
FAN1, FAN2 with rotate sense.
FAN3, FAN4 without rotate sense.
SENSE
GND +12V
1
JP
13
ATXPWR
FA
N
2
1
1
FAN3
1
FA
N
4
FA
N
1
1
