- 70 -
UART Mode Select
The main board support IrDA infrared through COM 2 port.
Note : FIR is not available currently.
"
The choice: IrDA, ASKIR, or Normal.
RxD, TxD Active
This item specifies the Active level for RxD & TxD signal.
"
The choice: Hi,Lo, Lo,Hi, Lo,Lo, or Hi, Hi.
IR Transmittion delay
This item enable/disable the delay of the IR state change from Rx to Tx
mode or Tx to Rx mode.
"
The choice:
Enabled, Disabled.
UR2 Duplex Mode
This item specifies onboard infrared transfer mode to full-duplex. This
item will not show up when IrDA, ASKIR modes are selected.
"
The choice:
Full, Half.
Use IR Pins
This item select the InfraRed module pin out.
"
The choice:
IR-Rx2Tx2 or RxD2, TxD2.
Onboard Parallel Port
This item allows you to determine onboard parallel port controller I/O
address setting.
"
The choice:: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, or Disabled.
Parallel Port Mode
Select an operating mode for the onboard parallel (printer) port. Select
Normal, Compatible, or SPP unless you are certain your hardware and
software both support one of the other available modes.
"
The choice: SPP, EPP, ECP, or ECP+EPP.
EPP Mode Select
Select a DMA channel for the parallel port for use during ECP mode.
"
The choice: EPP1.7 or EPP1.9.
