- 37 -
F
Other Connectors
ATX Power Supply Connector (JWR1)
Locate the 20-pin male header ATX power connector (JWR1) on your
mainboard. Plug the power cable from the ATX power supply unit directly
into JWR1 ATX power supply connector.
Note 1:
The ATX power connector is directional and will not go in unless the
guides match perfectly making sure that pin#1 is properly positioned.
Note 2:
Make sure the latch of the ATX power connector clicks into place to
ensure a solid attachment.
Note 3:
Your ATX power supply must be supplied to ACPI +5V standby power
and at least 720mA compatible.
Note 4:
Make sure your power supply have enough power for higher speed
processor installed.
Cooling Fan Connectors for CPU (FAN1/2)
The mainboard provides two onboard 12V cooling fan power connectors to
support CPU and Chassis cooler.
E1
E2
Note:
Both cable wiring and type of plug
may vary depending on the fan
maker. Keep in mind that the red
wire should always be connected
to the +12V header, and the black
wire, to the ground (GND) header.
SENSE
GND +12V
1
JW
R
1
1
FAN1
1
FA
N
2
1
