![background image](http://html.mh-extra.com/html/shure/uhf-wireless-microphone-system/uhf-wireless-microphone-system_user-manual_1262462021.webp)
ENGLISH
20
TRANSMITTER SETUP
Transmitter Battery Installation (Figure 34)
1. Make sure the transmitter power ON/OFF switch is in the OFF position.
2. Open the transmitter battery compartment as follows:
•
U1 Transmitter:
Squeeze the two tabs on either side of the transmitter and flip the
battery cover down.
•
U2 Transmitter:
Unscrew the battery cover and slide it down.
FIGURE 34
1.5V AA
1.5V AA
1.5V AA
1.5V AA
3. Remove the old batteries as follows:
•
U1 Transmitter:
Press down on the negative terminal end of each battery.
•
U2 Transmitter:
Lift the batteries out.
4. Install two fresh 1.5 V AA alkaline batteries. Make sure the battery terminals
match the terminals in the transmitter.
5. Close the battery cover.
IMPORTANT: Two fresh 1.5 V AA alkaline batteries should provide 8 to 12
hours of operation. However, nickel-cadmium (nicad) batteries may only
provide up to 3 hours of operation. Carbon-zinc and zinc-chloride batter-
ies will not provide sufficient power, and are not recommended.
Summary of Contents for UHF WIRELESS microphone system
Page 1: ......