Shure Incorporated
5/14
⑧
Ethernet Link Speed LED (Amber)
•
Off = 10 Mbps
•
On = 100 Mbps
⑨
Ethernet Status LED (Green)
•
Off = No network link
•
On = Network link established
•
Flashing = Network link active
⑩
Power Input
Connect to power supply.
⑪
Charger Connector (with rubber covers)
Use supplied screws and Allen wrench to connect up to 4 chargers to 1 power supply.
Power
1. Connect DC power cable to input jack. Finger tighten lock nut for a secure connection.
2. Connect power supply to AC power outlet.
WARNING:
•
Do not use pliers or any other tools to tighten lock nut. DC power cable must be attached before charger unit is
installed.
•
Do not plug in power supply unit until DC connection and charger are in place.
•
After securing the charger, plug the power cable into a properly grounded outlet.
The charger has no power switch. When plugged in, the power LED illuminates. The charging LEDs illuminate af
ter batteries are inserted.
Power Save Mode
Use power save mode to charge batteries with the charger’s network functionality off.
1. Disconnect the power cable from the AC power outlet.
2. Press and hold storage while reconnecting to the AC power outlet.
3. When the charge status and error LEDs flash amber, release the button.
The charger remains in power save mode until you power off the charger.
Note:
Transmitters docked with the power switch in the ON
position will power on when fully charged. To avoid un
wanted audio and unnecessary battery drain, ensure all transmitters are switched OFF before charging.
