![background image](http://html1.mh-extra.com/html/shure/qlx-d-series/qlx-d-series_user-manual_1262413039.webp)
Shure Incorporated
39/60
◦
◦
◦
◦
◦
◦
Adjust the system gain on the front of the receiver. Ensure the
mic/line
switch setting (XLR output only) on the back of the re
ceiver corresponds to the input of the mixing console, amplifier, or processor.
Cables
Check that all cables and connectors are fully engaged or locked into position. Inspect cables for damage. Replace if neces
sary.
Interface Locks
The transmitter and the receiver can be locked to prevent accidental or unauthorized changes. If a locked control is accessed,
the lock icon on the display will flash. Follow the instructions to unlock the receiver or transmitter.
Firmware Mismatch
Paired transmitters and receivers must have the same firmware version installed to ensure consistent operation. See Firmware
Updates topic for firmware update procedure.
Encryption Mismatch
Indicates an encryption key mismatch has been detected. Perform an IR sync between the receiver and transmitter to clear the
error.
Custom Group IR Sync
When using Custom Groups, always perform an IR sync from the
Custom Groups
menu in the receiver to ensure accurate dis
play of group and channel information. See
Custom Groups
topic for additional details.
Radio Frequency (RF)
The blue RF LED will illuminate when a linked transmitter is within range of the receiver. Measure the transmitter range before
a performance to avoid operating beyond the specified transmitter range.
The RF meter bars indicate amount of RF power being received. This signal could be from the transmitter,
or it could be from
an interfering source, such as a television broadcast
. If the meter shows a signal level when the transmitter is off, then that
channel may have interference. Check the surrounding area for sources of interference or change the receiver to a clear fre
quency.
A red
RF
LED indicates RF overload. Avoid operating multiple systems in close proximity.
Frequency Compatibility
Perform a Scan and Sync to ensure the transmitter and receiver are set to the same channel or frequency
Look at the label on the transmitter and receiver to make sure they are in the same band (G50, J50, L50, etc...).
Reducing Interference
Perform a scan to find the best open frequency. Perform an IR sync to transfer the settings to the transmitter.
For multiple systems, make sure that each receiver is assigned to a unique channel. Interference will occur if two transmit
ters are set to the same channel.
Maintain a line of sight between transmitter and receiver antennas.
Move receiver antennas away from metal objects or other sources of RF interference (such as CD players, computers, digi
tal effects, network switches, network cables and Personal Stereo Monitor (PSM) wireless systems).