Shure Incorporated
7/44
1.
2.
3.
1.
Step 3: Route Audio
To route audio to other Dante devices, use Dante Controller.
Open Dante Controller and find the MXA920 in the list of transmitters. With automatic coverage on, the MXA920 only
sends audio from the automix output. Transmit channels 1-8 only work when automatic coverage is off.
Find the Dante device you're sending audio to in the list of receivers. To make an audio route, check the box where the
MXA920's automix output intersects with the receiver device's input channel.
Place a test call with the whole conferencing system. Adjust coverage, gain, and DSP as needed.
MXA920 Parts
Mute status LED
Customize LED color and behavior in Designer:
Device
configuration
>
Settings
>
Lights
.
Default Settings
Microphone Status
LED Color/Behavior
Active
Green (solid)
Muted
Red (solid)
Hardware identification
Green (flashing)
Firmware update in progress
Green (progresses along bar)
Reset
Network reset:
Red (progresses along bar)
Factory reset:
Triggers device power-up
Error
Red (split, alternate flashing)
Device power-up
Multi-color flash, then blue (moves quickly back and forth
across bar)
Note:
If LEDs are disabled, they will still turn on when the device powers up or when an error state occurs.
