Shure MICROFLEX SERIES, Manual

Page: 15 / 48

10
System Setup
Connect the Components to Form a Network
The following are two setup examples for the MXW system. See Networking section for more details on Dante digital audio and networking best practices.
Single Group System (Automatic
Configuration)
Use a Cat5e cable to connect the charger and APT to one of four ports of
the ANI network interface. Reference the table for connecting to the ports:
Port To Component
① Port 1 (PoE) APT
② Port 2 Charger
④ Port 4 (Uplink) Computer (optional)
Requirements:
• Cat 5e (or higher) Shielded Ethernet Cables (≤100 m)
++++++++ ++
www.shure.com
MXWANI8
M X W A N I 8
uplin k Input: 100-240V ~ 1A max. 50/60 Hz
2 3 4
Class 0 Po E
1
++++++++ ++
www.shure.com
MXWANI8
M X W A N I 8
uplin k Input: 100-240V ~ 1A max. 50/60 Hz
2 3 4
Class 0 Po E
1
uplin k
2 3 4
Class 0 Po E
1
Class 0 Po E
1
②
①
②
③
①
7 8 6 5
1 2 3 4
7 8 6
5
1 2 3
4
15V 0.6A
power
④
③
Link
Power
Single-Group System
Multiple Group System
Follow these steps for connecting a multiple-group system:
1. Connect a DHCP enabled router to a computer.
2. Connect each charger and audio output device to the router with network
cables
3. Connect each access point to the network via a PoE source.
Requirements:
• Cat 5e (or higher) Shielded Ethernet Cables (≤100 m)
•
Gigabit Ethernet switch (DHCP-enabled router recommended)
• Computer
Four-Group System
++++++++ ++
www.shure.com
MXWANI8
M X W A N I 8
uplin k
Input: 100-240V ~ 1A max. 50/60 Hz
2 3 4
Class 0 Po E
1
++++++++ ++
www.shure.com
MXWANI8
M X W A N I 8
uplin k Input: 100-240V ~ 1A max. 50/60 Hz
2 3 4
Class 0 Po E
1
++++++++ ++
www.shure.com
MXWANI8
M X W A N I 8
uplin k Input: 100-240V ~ 1A max. 50/60 Hz
2 3 4
Class 0 Po E
1
++++++++ ++
www.shure.com
MXWANI8
M X W A N I 8
uplin k Input: 100-240V ~ 1A max. 50/60 Hz
2 3 4
Class 0 Po E
1
7 8 6 5
1 2 3 4
7 8 6 5
1 2 3 4
7 8 6 5
1 2 3 4
7 8 6
5
1 2 3 4
ON OFF
DHCP
ON OFF
DHCP
ON OFF
DHCP
PoE
10/02/12