Shure Incorporated
31/59
1.
2.
3.
4.
5.
6.
(2.1) Masking off the extrusion (highlighted in black)
Step 3: Reassembly
Secure the foam piece with the hook-and-loop fastener strips around the edges.
Slide the grille back into the frame.
Attach the remaining side of the frame and secure it with the 4 screws.
Attach the LED lightpipe into the black plastic guide piece.
Align the LED with the lightpipe and put the assembly back in place on the frame.
Note:
The label on the assembly is placed on the corner that corresponds to the LED. Use it for reference to ensure proper orientation during re
assembly.
Install the screws (6 per side) to secure the main assembly to the frame. Do not over-tighten.
Cable Management
To keep the Ethernet cable out of view, use the appropriate method based on the installation type.
Installation
Cable Solution
Ceiling grid
Run the cable above the ceiling grid
VESA (pole mounting)
Guide the cable through the pole to run it above the ceiling
grid
4-point wire suspension
Use cable ties to attach the CAT5 cable along one of the
hanging wires
Hard ceiling
Run the cable above the ceiling
Note:
If using conduit to contain the cable, the optional junction box accessory (model A910-JB) mounts directly to the rear panel of the microphone.
Note:
For ceiling grid installations, see the Notice or visit
Installing the Junction Box Accessory
The A910-JB junction box mounts on the microphone, enabling conduit connections for cable runs. Refer to local building
codes and regulations to determine if the junction box is necessary. There are three punch-out sections on the junction box for
attaching conduit.
Summary of Contents for Microflex Advance MXA910
Page 28: ...Shure Incorporated 28 59...
