![background image](http://html1.mh-extra.com/html/shure/microflex-advance-mxa910/microflex-advance-mxa910_manual_1261880048.webp)
Shure Incorporated
48/59
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
◦
•
◦
◦
Networking Terminology
PTP (Precision Time Protocol):
Used to synchronize clocks on the network
DSCP (Differentiated Services Code Point):
Standardized identification method for data used in layer 3 QoS prioritization
Switch and Cable Recommendations for Dante Networking
Switches and cables determine how well your audio network performs. Use highquality switches and cables to make your au
dio network more reliable.
Network switches should have:
Gigabit ports. 10/100 switches may work on small networks, but gigabit switches perform better.
Power over Ethernet (PoE) or PoE+ ports for any devices that require power
Management features to provide information about port speed, error counters, and bandwidth used
Ability to switch off Energy Efficient Ethernet (EEE). EEE (also known as "Green Ethernet") may cause audio dropouts and
problems with clock synchronization.
Diffserv (DSCP) Quality of Service (QoS) with strict priority and 4 queues
Ethernet cables should be:
Cat5e or better
Shielded
For more information,
about switches to avoid.
Networking Best Practices
Use the following best practices when setting up a network to ensure reliable communication:
Always use a "star" network topology by connecting each component directly to the switch or router.
Connect all Shure networked devices to the
same network
and set to the
same subnet
. It is also required in order to
open the web application for a device.
Devices on separate networks require an audio processor or conferencing software to carry audio between them. See the
system planning and gear requirements section for network setup information and configuration examples.
Use only 1 DHCP server per network. Disable DHCP addressing on additional servers.
Power on the switch and DHCP server prior to MXA equipment.
To expand the network, use multiple Ethernet switches in a star topology.
All devices must be at the same firmware revision level.
Device IP Configuration
This Shure device uses 2 IP addresses: one for Shure control, and one for Dante audio and control.
Shure control
Carries data for Shure control software, firmware updates, and third-party control systems (such as AMX or Crestron)
Dante audio and control
Carries Dante digital audio and control data for Dante Controller
Requires a wired, gigabit Ethernet connection to operate
To access these settings in Designer, go to
[Your
device]
>
Settings
>
IP
configuration
.
Device IP Settings
Configure IP
Summary of Contents for Microflex Advance MXA910
Page 28: ...Shure Incorporated 28 59...