Shure Beta 58, User Manual

Page: 10 / 52

10
ULX1, ULX2, ULXS4, ULXP4
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003
du Canada.
Meets requirements of EMC standards EN 300 422 Parts 1 and 2 and EN
301 489 Parts 1 and 9.
Meets essential requirements of European R&TTE Directive 99/5/EC,
eligible to bear the CE mark.
ULX1, ULX2
Certified under FCC Part 74. ( FCC ID: DD4ULX1, DD4ULX2,
DD4ULX1G3, DD4ULX2G3). Certified by IC in Canada under RSS-123
and RSS-102. ( IC: 616A-ULX1, 616A-ULX2).
ULXS4, ULXP4
Approved under the Declaration of Conformity (DoC) provision of FCC
Part 15. Certified in Canada by IC to RSS-123. ( IC: 616A-ULX4).
Conforms to European Regulation (EC) No. 1275/2008, as amended.
Operation of this device is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation
of the device.
The CE Declaration of Conformity can be obtained from Shure
Incorporated or any of its European representatives. For contact informa-
tion please visit www.shure.com
The CE Declaration of Conformity can be obtained from: www.shure.com/
europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Wannenacker Str. 28
D-74078 Heilbronn, Germany
Phone: +49 7131 72 14 0
Fax: +49 7131 72 14 14
Email: EMEAsupport@shure.de
LICENSING INFORMATION
Licensing: A ministerial license to operate this equipment may be re-
quired in certain areas. Consult your national authority for possible
requirements. Changes or modifications not expressly approved by
Shure Incorporated could void your authority to operate the equipment.
Licensing of Shure wireless microphone equipment is the user’s respon-
sibility, and licensability depends on the user’s classification and applica-
tion, and on the selected frequency. Shure strongly urges the user to
contact the appropriate telecommunications authority concerning proper
licensing, and before choosing and ordering frequencies.
Information to the user
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note: EMC conformance testing is based on the use of supplied and rec-
ommended cable types. The use of other cable types may degrade EMC
performance.
Changes or modifications not expressly approved by the manufac-
turer could void the user’s authority to operate the equipment.
WARNING: Dispose of properly. Check with local vendor for
proper disposal of used battery and electronics.
CERTIFICATION