English
7
SPECIFICATIONS
SYSTEM SPECIFICATIONS
Frequency Range:
(NOTE: Available frequen-
cies depend on applicable
regulations in country where
the system is used.)
Approximately 596 MHz to 862 MHz
Operating Range:
100 m (approximately 300 ft.) under
typical conditions
Audio Frequency
Response:
20 to 16,000 Hz
±
3 dB
Image Rejection:
75 dB typical
Spurious Rejection:
75 dB typical
System Distortion
(ref.
45 kHz deviation,
1 kHz modulation):
0.1% THD typical
Signal-to-Noise Ratio:
90 dB
Maximum Recommended
Input Level, AXU1 (attenua-
tion switch at –20 dB, gain
at +32 dBV):
–110 dBm for 12 dB SINAD typical
Minimum Recommended
Input Level, AXU1 (attenu-
ation switch at 0 dB, gain
at –80 dBV):
-80 dB
Operating Temperature
Range:
(NOTE: Battery characteris-
tics may limit range)
7
°
to 38
°
C (45
°
to 100
°
) F
Transmitter Battery Life:
12 hours with 9 V alkaline battery
(Duracell MN1604 recommended).
BODY-PACK TRANSMITTER SPECIFICATIONS
RF Output:
15 mW Typical
Input Configuration:
Unbalanced
Connector Type:
4-pin Tini QG (male)
Actual Impedance:
1 M
Ω
Connector Pin Assign-
ments:
Pin 1:Tied to Ground
Pin 2:Tied to +5 V
Pin 3:Tied to Audio
Pin 4:Tied to 20k
Ω
Resistor and
Audio Ground
Dimensions:
82.6 mm H x 63.5 mm W x 26.2 mm
D
(3.25” H x 2.50” W x 1.03” D)
Net Weight:
125g (4.4 oz.) including battery
Power Requirements:
9 V alkaline battery
(Duracell MN1604 recommended);
9 V lithium battery optional.
Nominal Current Drain:
40 mA
* Gain Control at minimum
** Gain Control at maximum
HAND-HELD TRANSMITTER SPECIFICATIONS
RF Output:
15 mW Typical
Dimensions:
241 mm H x 51 mm D
(9.49 in. H x 2.01 in. D)
Net Weight:
296g (10.4 oz.)
Power Requirement:
9 V alkaline battery
(Duracell MN1604 recommended);
9 V lithium battery optional.
Nominal Current Drain:
40 mA
RECEIVER SPECIFICATIONS
Connector:
3-Pin XLR (male)
1/4” phone plug (female)
Maximum Output Levels:
Line Level: +10 dBV
Mic Level: –22 dBV
+4 dBV
Nominal Output Levels:
Line Level: –22 dBV
Mic Level: –46 dBV
–26 dBV
Output
Configuration:
Active Balanced
Unbalanced
Actual Impedance:
Line Level: 5.5 k
Ω
Mic Level: 500
Ω
1 k
Ω
Connector Pin
Assignments:
Pin 1: ground
Pin 2: hot
Pin 3: cold
Tip: hot
Sleeve: ground
Dimensions:
41 mm H x 197 mm W x 138 mm D (1.625 in. H x 7.77 in. W x 5.42
in. D)
Net Weight:
419.6g (14.8 oz.)
Power
Requirements:
12–18 VDC nominal, 200mA
Power Supply:
120 V or 230V AC adaptor with 2.1 mm female plug
Voltage/Current/Phantom
Power Protection:
Yes
Yes
