5
Device ID
The device ID identifies the transmitter on a
network in WWB software or when linked to
a receiver.
• ID length can be up to 8 characters
• Use arrow buttons to scroll through
characters
• Use
Set
button to save and move to next
character
Frequency
Press the
set
button once to highlight the
first 3 digits for editing, or twice to highlight
all digits for editing. Use the arrow buttons
to change each digit.
When finished, press the
set
button to save
changes.
RF Mute
Disables the RF signal to mute the audio
output.
TX On:
Audio output on
TX Off:
Audio output muted
Gain
Adjust the gain to set audio output level.
Gain range is -10 to +20 dB, in 1 dB steps.
Sens
(sensitivity)
Adjust the sensitivity to compensate for input
level variation.
Sensitivity settings are 0 or +12 dB
RF PWR
From the main menu screen, press and hold the
▼ and
set
button to edit the RF power level.
Use lower power settings to conserve battery life
and to prevent RF overload at the receiver.
Note:
A password is required in some regions.
Firmware
Displays the firmware version installed in the
transmitter
Unlink
The unlink command ends the linking relation-
ship between a transmitter and a receiver.
YES:
Ends the link between a transmitter and a
receiver.
NO:
Preserves the link between a transmitter
and a receiver.
Note: When a transmitter is unlinked, the chan-
nel name will revert to
unlinked
.
PCB Serial Number
Use this menu to view the serial number of the
printed circuit board (
PCB
) installed in the unit.
1. From the main menu screen, press and
hold the ▼ and “set” buttons to enter the
RF
Power
screen.
2. Press the▲ button to access the serial num-
ber .
3. Momentarily press the power button to return
to the home menu screen.
AA Type
Sets the AA battery type to ensure accurate
runtime display when using the optional battery
sled.
Alkaline
NiMH
Lithium
Showlink Test
Activates the ShowLink test 5-bar display to
measure the control range of a ShowLink ac-
cess point.
• 5 bars indicate the center of the coverage
area
• 1 bar indicates the outer boundary of the
coverage area
• If bars are not displayed, ShowLink control is
not available
Troubleshooting
Input Overload
The
Input Overload
message indicates an excessive signal level at
the transmitter input. To remove an overload, reduce the gain or sensi-
tivity settings.
No ShowLink Alert
This alert is appears if you try to change the frequency when the trans-
mitter is beyond the range of an active ShowLink access point. Choose
OK
to unlink the transmitter and complete the frequency change, or
Cancel
to return to the home screen.
Group (G) and Channel (C)
A group is a set of pre-set frequencies. A single
frequency within a group is a channel.
G:
Change the group
C:
Change the channel
Firmware Updates
Firmware is embedded software in each Axient component that controls functionality. Periodically, new versions of firmware are developed to in-
corporate additional features and enhancements. To take advantage of design improvements, new versions of the firmware can be uploaded and
installed using the Firmware Update Manager tool available in WWB6 software. Firmware is available for download from .
Parameter Menus
To adjust transmitter settings, use the arrow buttons to access and edit the parameter menus.
Input
Overload
No ShowLink.
UNLINK Tx to
change freq?
OK Cancel
Draft
6/7/11
