![background image](http://html1.mh-extra.com/html/shure/advance-mxa310/advance-mxa310_manual_1261650044.webp)
Shure Incorporated
44/55
•
•
•
1.
2.
Tip:
For larger wireless microphone configurations, it’s recommended to increase the multicast transmission rate to provide adequate bandwidth.
Important:
For best performance, use a Wi-Fi router that does not limit the multicast rate to 1-2 Mbps.
Shure recommends the following Wi-Fi router brands:
Cisco
Linksys
Apple
Packet Bridge
Packet bridge enables an external controller to obtain IP information from the control interface of a Shure device. To access the
packet bridge, an external controller must send a query packet over
unicast UDP*
to
port 2203
on the Dante interface of the
Shure device.
Send a UDP packet with a minimum 1-byte payload .
Note:
The maximum accepted payload 140 bytes. Any content is allowed.
The Shure device will send a response packet over unicast UDP to the controller, using a destination UDP port identical
to the source port of the query packet. The payload of the response packet follows this format:
Bytes
Content
0-3
IP address, as 32-bit unsigned integer in network order
4-7
Subnet mask, as 32-bit unsigned integer in network or-
der
8-13
MAC address, as array of 6 bytes
Note:
The Shure device should respond in less than one second on a typical network. If there is no response, try sending the query again after verify
ing the destination IP address and port number.
*UDP:
User Datagram Protocol
IP Ports and Protocols
Shure Control
Port
TCP/UDP
Protocol
Description
Factory De
fault
21
tcp
FTP
Required for firmware updates (otherwise closed)
Closed
22
tcp
SSH
Secure Shell Interface
Closed
23
tcp
Telnet
Not supported
Closed
68
udp
DHCP
Dynamic Host Configuration Protocol
Open
80*
tcp
HTTP
Required to launch embedded web server
Open
443
tcp
HTTPS
Not supported
Closed
161
tcp
SNMP
Not supported
Closed
162
tcp
SNMP
Not supported
Closed