P/N 1808554 Rev. D
2
There must be at least 6" clearance between components and
tilt frame. If existing exhaust system or hydraulic system compo
-
nents are located between tilt frame and cab, adjust component
locations as needed to achieve 6" of clearance.
If existing components interfere with base assembly installation,
and if moving existing components is not practical, fabricate
brackets as needed to prevent interference.
STEP 1:
Locate mounting angles on both sides of truck frame,
centering brackets between cab and tilt frame. Align
angles on frame, mark and drill 5/8" holes and fasten
with 5/8" x 2" cap screws, flat washers and lock nuts
(supplied by customer) or weld in place (see caution).
Base Assembly Installation
CLEARANCE REQUIREMENTS
BASE ASSEMBLY INSTALLATION
CAUTION
Welding components to truck frame may weaken
frame and will void warranty on truck. Weld angle
brackets to existing brackets on frame when pos-
sible. When not possible, drill holes in frame and bolt
brackets in place.
!
CAUTION
To prevent damage to and ensure proper operation
of Quick Flip II™ system, center base assembly be-
tween cab and hoist with at least 6" of clearance.
!
6"
minimum
cab
tilt
frame
STEP 2:
Align and center mounting channel on mounting
angles and weld in place.
mounting
channel
mounting
angle
Item Part #
Description
1. 180
1622 Base Assembly
2. 1800726 M
ounting Channel
3. 1801966 Mounting Angle
hardware
supplied
by
customer
supplied
by
customer
tilt
frame
cab
mounting
angle
2
1
3
STEP 3:
Square and center
base assembly on
mounting channel.
Weld legs to mount
-
ing channel.
NOTE:
If needed, fabricate
additional bracing to
stabilize base assembly
and mounting channel.
mounting
channel
base
assembly
