12
Cleaning and Maintenance
1. Press STOP button and wait until the motor completely stops.
2. Using dry hands, unplug the power cord from electrical outlet.
3. Disassemble the machine.
4. Wash the Lid and Cap in warm soapy water. Rinse and dry thoroughly before first use.
NOTE:
DO NOT put unit in dishwasher. We recommend washing the Pitcher by hand. For safety
reasons, do not touch the blade directly with your fingers. Fill the Pitcher with warm soapy water.
Attach the Pitcher to the Base. Then secure the Lid and Cap in place. Connect Power Cord to
outlet. Press POWER then Press EMULSIFY button. Increase the speed to 8. Allow unit to run
for about 1 minute. Rinse and dry thoroughly.
6. Make sure Base and parts are completely dry before storing in a cool, dry place.
7. Never use abrasive materials or cleansers to clean the main Base or any of the parts. This can
scratch the finish causing permanent damage.
CAUTION:
To avoid personal injury use caution while cleaning inside of Pitcher as Blades
are sharp. Handle carefully.
NOTE:
The
Shred Emulsifier
TM
is a very powerful unit. When operating properly, the motor
gives off a loud but smooth sound that changes in pitch as the motor speed is increased.
This is normal.
NOTE:
In the event the motor overheats during operation it will automatically shut off. You may
have overloaded the
Shred Emulsifier
TM
. Remove excess contents. To restore power, allow the
machine to cool down for 35 minutes before use.
Troubleshooting
Problem
Possible Reasons and Solution
There was a burning smell when
the
Shred Emulsifier
TM
was first
turned on.
• There may be a short term Burn-Off Odor when
the
Shred Emulsifier
TM
is first used. This is from a
lubricant used in manufacturing the motor
Motor does not run after Emulsify
button is pushed.
• Check to see if unit is plugged in.
• Pitcher is not seated correctly.
• Check if all parts are assembled properly.
• Check if any food is causing Blade to lock.
Normal Loud Smooth Sound
becomes unpleasant, more
pronounced and uneven,
producing erratic and sometimes
uncontrolled unit vibration.
• Push power button to OFF immediately.
• Unplug unit and check for proper assembly.
• Reassemble and retry unit.
The unit shuts off
while in use.
• The auto shut off feature has been activated due
to overheating.
• Push OFF button, allow to cool down
for 35 minutes.
• Check the thickness and quantity of mixture, if
overloaded, reduce accordingly.
Summary of Contents for SE1-PRO
Page 15: ......
