18
Ordercode: 40429
Star Dream 6x3m 128 LED RGB
2. Static Colors
In this menu you can set the static colors.
In order to be able to operate the Star Dream in this mode, disconnect the DMX cable from
the DMX input (03).
If you do not remove the cable, the light output will be blacked out.
01)
While in the main menu, press the UP/DOWN buttons, until the display shows
.
02)
Press the ENTER button to open the menu. The display will show either of the 2 screens, depending
on the current color mode setting (RGB or White):
RGB mode
White mode
Please note that the selectable static colors depend on the currently active color mode
(RGB or White).
Before you start programming, make sure that the device is in the appropriate color mode.
See page 23 for more information about setting the color mode.
03)
Press the UP/DOWN buttons to select the desired static color (only in RGB mode).
04)
Press the ENTER button to edit the color.
05)
Press the UP/DOWN buttons to set the color brightness. The adjustment range is between 0–255, from
dark to brightest.
06)
Press the ENTER button again, to save changes and to proceed to strobe settings.
07)
Press the UP/DOWN buttons to set the strobe frequency. The adjustment range is between 0–100,
from OFF to high frequency.
08)
Press the ENTER button to save changes.
