SHOWTEC Spectral M1000 Tour Q4 MKII, Manual

Page: 21 / 40

20
Ordercode: 43550
Spectral M1000 Tour Q4 MKII
7. Settings
With this menu you can set the device’s settings.
01)
Press the UP/DOWN buttons until the display shows .
02) Press the ENTER button to open the menu.
7.1. Password
01) When the display shows , press the ENTER button to open the menu.
02) Press the UP/DOWN buttons to choose between ON and OFF.
03) If you have selected ON, press the ENTER button to confirm.
04) It will now take 30 seconds for the device to become locked.
05) If this options remains active, the device will always ask for the password on start up.
06) In order to unlock the device, press the following buttons in the following order:
UP>DOWN>UP>DOWN .
7.2. Upload
With this menu, you can export current programs from the master device to the connected slave
devices.
01)
Press the UP/DOWN buttons until the display shows .
02) Press the ENTER button to open the menu.
03) Insert the password: UP>DOWN>UP>DOWN and press the ENTER button to confirm.
04) The display will show SEND.
05) Press the ENTER button again, to confirm.
06) The display will show END and the programs will have been exported.
07) While exporting , the slave devices will light up yellow .
08) If there are any problems with exporting , the master and the slave devices will light up red .
09) If the operation was completed successfully , the master and the slave devices will light up green .
7.3. Reset
With this menu, you can reset the custom programs.
01)
Press the UP/DOWN buttons until the display shows .
02) Press the ENTER button to open the menu.
03) Insert the password: UP>DOWN>UP>DOWN and press the ENTER button to confirm.
04) The display will show OK and the custom programs will have been reset.
7.4. Color
With this menu, you can adjust the color calibration functions.
01)
Press the UP/DOWN buttons until the display shows .
02) Press the ENTER button to open the menu.
03) Press the UP/DOWN buttons to toggle between the following 3 options:
RGB to White
Off
Adjusted output
04)
When the display shows , RGB to White is active. This means RGB = 255,255,255. The color
displayed is the specific color which you have calibrated in CAL

CAL2

RGBW menu.
05) When the display shows , the RGB settings are: 255,255,255. The RGB values are not adjusted
and the output is the most powerful. The parameters can be adjusted in CAL

CAL2

RGBW menu.
06) When the display shows , the RGB output is adjusted to a standard preset universal color. In
this way, different Spectral versions are color-balanced in order to match each other.