SHOWTEC Spectral M1000 Tour Q4 MKII, Manual

Page: 11 / 40

10
Ordercode: 43550
Spectral M1000 Tour Q4 MKII
Control Modes
There are 4 modes:
• Static Colors (Manual)
• Built-in programs (Auto)
• Master/Slave
• DMX-512 (3CH, 3CH, 4CH, 4CH, 5CH, 6CH, 6CH, 8CH, 10CH, 15CH, 23CH)
One Spectral (Static Colors)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Spectral is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 16 for more information about the static colors.
One Spectral (Built-in programs)
04) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
05) Plug the end of the electric mains power cord into a proper electric power supply socket.
06) When the Spectral is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 17 for more information about the built-in programs.
Multiple Spectrals (Master/Slave control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin XLR cable to connect the Spectral.
The pins: 01) Earth
02) Signal -
03) Signal +
03)
Link the units as shown in fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on pages 16-17 (Static colors or
Built-in programs). This means that you can set your desired operation mode on the master device
and all slave devices will react the same as the master device.
Multiple Spectrals (Master/Slave control)
Fig. 03