10
Multiple Spectrals (Master/Slave control)
1.
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Use a 3-p XLR cable to connect the Spectral.
The pins:
1.
Earth
2.
Signal -
3.
Signal +
3.
Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can
use the same functions on the master device as described on page 16+17 (Static Colors or Built-in
Programs
). This means on the master device you can set your desired operation Mode and all slave
devices will react the same as the master device.
Multiple Spectrals (Master/Slave control)
Fig. 3
Multiple Spectrals (DMX Control)
1.
Plug the end of the electric mains power cord into a proper electric power supply socket
.
2.
Use a 3-p XLR cable to connect the Spectrals
.
3.
Link the units as shown in (figure 4), Connect a DMX signal cable from the first unit's DMX "out" socket
to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units
.
4.
Supply electric power: Plug the end of the mains power cord into proper electric power supply
sockets. Do so for all units and the controller
. Do not supply power before the whole system is set up
and connected properly.
Summary of Contents for Spectral D5000
Page 16: ...14 Menu Overview...
Page 27: ......