Ordercode: 90660
PowerBOX 3
Unlinking
01)
Press the Function button (05) to unlink the PowerBOX 3 receiver.
02)
The PowerBOX 3 is now ready to be linked to another DMX transmitter.
LED Status Indicator
While linking/unlinking, observe the LED status indicator (07).
01)
When the LED is OFF, the PowerBOX 3 is not linked to any transmitter.
02)
When the LED is blinking slowly, the PowerBOX 3 is linked to a transmitter but does not receive any
DMX signal.
03)
When the LED is continuously ON, the PowerBOX 3 is linked to a transmitter and receives a DMX
signal.
04)
When the LED is blinking quickly, the linking process is in progress or the connection is weak/lost.
Maintenance
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by a skilled person once a year.
We strongly advise you to let a qualified technician give the unit a maintenance check twice a year.
The following points have to be considered during the inspection:
01)
All screws used for installing the device or parts of the device have to be tightly connected and
must not be corroded.
02)
There may not be any deformations on housings, fixations and installation spots.
03)
Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
04)
The electric power supply cables must not show any damages or material fatigue.
The PowerBOX 3 requires almost no maintenance. However, you should keep the unit clean. Disconnect
the mains power supply, and then wipe the cover with a damp cloth. Do not immerse in liquid. Do not
use alcohol or solvents.
Keep connections clean. Disconnect electric power, and then wipe the DMX and power connections
with a damp cloth. Make sure connections are thoroughly dry before linking equipment or supplying
electric power.
Troubleshooting
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
01)
If the device does not operate properly, unplug the device.
02)
Check power from the wall, all cables, the settings (return to default), etc.
03)
If all of the above appears to be O.K., plug the unit in again.
04)
If nothing happens after 30 seconds, unplug the device.
05)
Return the device to your Showtec dealer.
8
Summary of Contents for POWERBOX 3
Page 11: ...Ordercode 90660 PowerBOX 3 10...
Page 12: ...2016 Showtec...
