30
Pixelbar 16 Q6
Product code: 41308
Slave Mode
In this menu you can activate master/slave control mode.
01)
Press the UP/DOWN buttons to select one of the following 2 options:
●
Master:
The device will operate as a master device in master/slave mode
●
Slave:
The device will operate as a slave device in master/slave mode
02)
Press the ENTER button to confirm the selection.
Set IP Mode
In this menu you can select the IP mode.
01)
Press the UP/DOWN buttons to select one of the following 3 options:
●
DHCP IP:
The IP address of the device will be generated automatically by the
network server
●
Static IP:
The IP address of the device can be configured manually. For more
information refer to 6.6.9. Set IP Address
●
KlingNet IP:
The IP address of the device will be generated automatically by the media
server
02)
Press the ENTER button to confirm the selection.
Set IP Address
If you have selected DHCP IP or KlingNet IP in 6.6.8. Set IP Mode above, when you select Set IP Address in
the menu, the display will show respectively the following:
The IP address of the device will be generated automatically by the
network server.
The IP address of the device will be generated automatically by the
Media Server.
If you have selected Static IP, you can configure the IP address of the device manually.
01)
Press the UP/DOWN buttons to move the cursor respectively to the left or to the right on the display.
When the cursor reaches the last available position on the line, it will move to the second line.
Press the ENTER button to confirm the selection. The selected number will be highlighted.
03)
Press the UP/DOWN buttons to change the number. The selection range is between 0 and 255.
Press the ENTER button to confirm.
Repeat steps 1–4 for each of the remaining 3 sections.
Press the UP/DOWN buttons to toggle between CANCEL (to discard changes) and ENTER (to confirm
the IP address).
07)
Press the ENTER button to confirm the selection.
