8
Ordercode: 40207
Phantom 75 MKII LED Spot
Backside
Fig. 02
03)
IEC 100-240V power connector IN
04)
IEC 100-240V power connector OUT
05)
Fuse F4A/250V
06)
3-pin DMX signal connector IN
07)
3-pin DMX signal connector OUT
Installation
Remove all packing materials from the Phantom 75 MKII LED Spot. Check if all foam and plastic padding
is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
