Ordercode: 40060
Phantom 300 LED Matrix
Control Panel
Press and turn the control to navigate through
the menu options
Fig. 07
DMX Control Mode
The fixtures are individually addressed on a data-link and connected to the controller. When a DMX
signal is present, the DMX LED will blink.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the Phantom 300 LED Matrix will respond to the controller.
Please note when you use the controller, the unit has 120 channels.
When using multiple Phantoms, make sure that you set the DMX addresses right.
Therefore, the DMX address of the first Phantom should be 1(001); the DMX address of the second
Phantom should be 1+120=121 (121); the DMX address of the third Phantom should be 121+120=241
(241), etc. Please, make sure that you do not have any overlapping channels in order to control each
Phantom correctly. If two or more Phantoms are addressed similarly, they will work similarly.
Controlling:
After having addressed all Phantom fixtures, you may now start operating these via your lighting
controller.
Note: After switching on, the Phantom 300 LED Matrix will automatically detect whether DMX 512 data is
received or not. If there is no data received at the DMX input, the DMX LED will not blink.
The problem may be:
•
The XLR cable from the controller is not connected with the input of the Phantom 300 LED Matrix.
•
The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It is necessary to insert an XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 35 seconds
When the MENU control is neither pressed nor turned for 35 seconds, the display will show the default
screen. To return to the main menu, you have to press or turn the MENU control (04).
Once you have pressed or turned the control, the display will show the main menu screen.
16
