SHOWTEC Performer 2000 Fresnel DDT MKII V2, Manual

Page: 22 / 32

21
Ordercode: 33037
Performer 2000 Fresnel DDT MKII
6.4. Performance Settings
01)
When the display shows PERFORM, press the ENTER button to open the menu.
02) Press the UP/DOWN buttons to toggle through the 3 modes:
LIVE
Default mode. It provides a compromise between output
quality and noise level.
STUDIO
Noise level-oriented mode. It emits little noise and operates at
moderate power level.
POWER
Output-oriented mode. The device does not offer any
consideration for noise level and operates at full power.
6.5. Settings Menu Safety Lock
01)
When the display shows SLOCK, press the ENTER button to open the menu.
02) Press the UP/DOWN buttons to toggle between ON and OFF to activate/deactivate the menu lock.
03) When the option is active, you will always need to insert the safety key/pass code in attempt to enter
the Settings menu.
6.6. DMX Channel Modes
With this menu you can set the desired DMX channel mode.
01)
When the display shows PERSONALITY, press the ENTER button to open the menu.
02) Press the UP/DOWN buttons to toggle through the 3 channel modes:
UNO 1-channel mode
DOS 2-channel mode
STD.P 5-channel mode
6.7. Save DMX/Blackout
01)
When the display shows DMX ERROR, press the ENTER button to open the menu.
02) Press the UP/DOWN buttons to toggle between the 2 options:
SAVE DMX data save
BLACK Blackout
03)
If the display shows SAVE, the Performer will utilize the last working DMX signal, which will ensure
undisrupted performance.
04) If the display shows BLACK, the Performer will black out the output, in case of a DMX signal error.
6.8. Reset Settings
01)
When the display shows RESET, press the ENTER button to enter the menu. The display will show PASS
CODE.
02) Insert the safety key combination by pressing the buttons in the following order: UP, DOWN, UP,
DOWN, ENTER.
03) The display will promptly show OK! and the settings will have been reset.
6.9. Mode Setting
01)
When the display shows MODE SETTING, press the ENTER button to open the menu.
02) Press the UP/DOWN buttons to toggle between the 2 options:
SELF DMX data transfer OFF
MASTER DMX data transfer ON
03)
If the display shows SELF, the Performer will not send DMX data to the other connected devices.
04) If the display shows MASTER, the Performer will send DMX data to the other connected devices.