SHOWTEC Mistique, Manual

Page: 17 / 56

16
Ordercode: 60769
Mistique
Control Modes
There are 2 modes: ● Stand-alone
● DMX512 (1CH, 3CH, 5CH)
One Mistique (Stand-alone)
01)
Leave at least 1 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the Mistique is not connected by a DMX cable, it functions as a stand-alone device.
04) Please see page 31 for more information about the stand alone mode.
Multiple Mistiques (DMX Control)
01)
Fasten the effect light onto firm trussing. Leave at least 1 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) Use a 3-pin/5-pin XLR cable to connect the Mistiques and other devices.
04) Link the units as shown in Fig. 04. Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
05) Supply electric power: Plug electric mains power cords into each unit's PowerCON socket, then plug
the other end of the mains power cord into proper electric power supply sockets, starting with the
first unit. Do not supply power before the whole system is set up and connected properly.
Multiple Mistiques DMX Set Up
Fig. 04
Note: Link all cables before connecting electric power