8
Ordercode: 41281
Candela Pix 100
Installation
Remove all packing materials from the Candela Pix 100.
Check that all foam and plastic padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Control Modes
There are 5 modes:
●
Auto program
●
Built-in programs
●
Manual
●
Master/Slave
●
DMX512 (CH4, CH6, CH9, CH56)
One Candela Pix (Auto program, Built-in programs and Manual control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
When the Candela Pix 100 is not connected with a DMX cable, it functions as a stand-alone device.
Please see page 14 for more information about the Auto program mode, Built-in programs or
Manual color mode.
Multiple Candela Pixs (
Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
Use a 3-p XLR cable to connect the Candela Pixs and other devices.
The pins:
1.
Earth
2.
Signal (-)
3.
Signal (+)
05)
Link the units as shown in Fig. 04, connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second and third unit. You can use the
same functions on the master device as described on page 14 (Auto program, Built-in programs or
Manual color mode). This means you can set your desired operation mode on the master device
and all slave devices will react the same as the master device.
Multiple
Candela Pixs (
Master/Slave control)
Fig. 04
Summary of Contents for Candela Pix 100
Page 27: ...26 Ordercode 41281 Candela Pix 100 Dimensions...
Page 28: ...2019 Showtec...
