11
Booby Trap RG
Product code: 43170
Installation Site Requirements
●
The device can be used only indoors.
●
The device can be mounted to a truss or other rigging structure.
●
The minimum distance to other objects must be bigger than 0,5 m.
●
The minimum distance between the light output and the illuminated surface must be bigger than
0,5 m.
●
The maximum ambient temperature t
a
= 40 °C must never be exceeded.
●
The relative humidity must not exceed 50 % with an ambient temperature of 40 °C.
Rigging
The device can be positioned on a flat surface or mounted to a truss or other rigging structure. Make sure
that all loads are within the pre-determined limits of the supporting structure.
CAUTION
Restrict the access under the work area during rigging and/or derigging.
To mount the device, follow the steps below:
01)
Use a clamp to attach the device to the supporting structure, as shown in Fig. 07. Make sure that the
device cannot move freely.
02)
Secure the device with a secondary suspension, for example a safety cable. Make sure that the
secondary suspension can hold 10 times the weight of the device. If possible, the secondary
suspension should be attached to a supporting structure independent of the primary suspension. Put
the safety cable around the mounting bracket (06), as shown in Fig. 05.
Fig. 05
Summary of Contents for Booby Trap RG 43170
Page 22: ...21 Booby Trap RG Product code 43170...
Page 23: ...22 Booby Trap RG Product code 43170...
Page 24: ...2021 Showtec...
