19
Pixel Bubble 75 Set
Product code: 44570
DMX Linking
To connect multiple devices on one DMX data link, follow the steps below:
01)
Use a 3-pin/5-pin DMX cable to connect the DMX OUT connector of the lighting controller to the
DMX IN connector of the first device.
02)
Connect the first device’s DMX OUT connector to the second device’s DMX IN connector with a
3-pin DMX cable.
03)
Repeat step 2 to connect all devices in a daisy-chain as shown in Fig. 08.
04)
Connect a DMX terminator (120 Ω resistor) to the DMX OUT connector of the last device on the data
link.
Fig. 08
DMX Addressing
In a setup with multiple devices, make sure that you set the DMX starting address of each device
correctly. The Pixel Bubble 75 has 2 personalities: 7 channels and max. 450 channels (1string 75 channels,
2 strings 150 channels, 3 strings 225 channels, 4 strings 300, 5 strings 375 channels, 6 strings 450 channels)
If you want to connect multiple devices on one data link and use them in 7-channel mode, for example,
follow the steps below:
01)
Set the starting address of the 1
st
device on the data link to 1 (001).
02)
Set the starting address of the 2
nd
device on the data link to 8 (008), as 1 + 7 = 8.
03)
Set the starting address of the 3
rd
device on the data link to 12 (012) as 8 + 7 = 12.
04)
Continue assigning the starting addresses of the remaining devices by adding each time 7 to the
previous number.
Make sure that you do not have any overlapping channels in order to control each Pixel Bubble 75
correctly. If two or more devices are addressed similarly, they will work similarly.
