SHOWTEC 44060, Manual

Page: 12 / 40

11
Ordercode: 44060
EventLITE 4/10 Q4
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Charging the Built-in Battery
01) In order to charge the battery, you need the included IEC power cable.
02) Turn off the power.
03) Connect the IEC power cable to the EventLITE.
04) Plug the other end of the IEC power cable into a proper electric power supply socket.
05) The charging indicator will light up red.
06) Charge the battery (up to 10 hours.)
07) Once the battery is fully charged, the charging indicator will light up green.
Important!
●
Do not charge the battery for more than 24 hours.
● Recharge within 3 days of use.
● When storing the device for more than 7 days, make sure that the power on/off switch is in OFF
position.
● Store in an upright position.
Control Modes
There are 7 modes: ● Auto
● Built-in programs
● Manual
● Master/Slave
● Wireless Master/Slave
● DMX512 (4CH, 6CH, 9CH)
● Wireless DMX (W-DMX)
One EventLITE (Auto)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the EventLITE is not connected with a DMX cable and Wireless DMX is switched off, it functions
as a stand-alone device. See page 24 for more information about Auto mode.
One EventLITE (Built-in programs)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the EventLITE is not connected with a DMX cable and Wireless DMX is switched off, it functions
as a stand-alone device. See page 24 for more information about Built-in programs.
One EventLITE (Manual)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Plug the end of the electric mains power cord into a proper electric power supply socket.
03) When the EventLITE is not connected with a DMX cable and Wireless DMX is switched off, it functions
as a stand-alone device. See page 23 for more information about Manual mode.