SHOWTEC 43548, User Manual

Page: 28 / 44

27
Spectral M3000 Zoom Q4 MKII IP65
Product code: 43548
How to make your own custom program
01) First, start with PR.C1 and add the desired settings in scene 1 (SC.01), then scene 2 (SC.02) , etc.
02) In this way you can add a maximum of 30 scenes.
03) After that, you can start with PR.C2 and create a maximum of 30 scenes again.
04) You can repeat these steps, until you’ve reached PR.10, step 30.
05) It is possible to create 300 separate scenes.
Settings
In this menu you can adjust the device’s settings. This menu requires a password. The default password is
pressing the UP/DOWN buttons in the following order: UP, DOWN, UP, DOWN.
01) Enter the password.
02) Press the ENTER button to confirm the password and access the menu.
03) Press the UP/DOWN buttons to select one of the following 7 options:
● UPLOAD: See 6.6.7.1. Upload
● RESET: See 6.6.7.2. Reset
● DIMMER: See 6.6.7.3. Dimmer
● DMX ERROR: See 6.6.7.4. DMX Error
● ZOOM: See 6.6.7.5. Zoom settings
● CURV: See 6.6.7.6. Dimming curve settings
● PWM: See 6.6.7.7. PWM Rate
04) Press the ENTER button to confirm the selection.
Upload
In this submenu you can export the custom programs from the master device to the connected slave
devices.
Select UPLOAD and press the ENTER button to open the submenu.
Enter the password, pressing the buttons in the following order: UP, DOWN, UP, DOWN.
Press the ENTER button to confirm the password.
While exporting, the light output of the slave devices will turn yellow and the display will show:
When the upload is finished, the display will show OK.
If there are any problems with exporting, the master and the slave devices will light in red.
If the operation was completed successfully, the master and the slave devices will light in green.