Master / Slave Operational Mode
23
SL NITRO 510C LED STROBE Luminaire
Installation & User’s Manual
Sh wline
6. Master / Slave Operational Mode
The Master / Slave Operational Mode allows one SL NITRO 510C LED STROBE Luminaire to act as the "Master"
unit and all other connected units are controlled by this unit. When a unit is set to "Slave" mode, it will only listen to
and follow any commands sent from a "Master" unit. Only one "Master" unit is allowed in this type of operation.
To setup a master / slave network:
Step 1. Set the first device in the DMX512 chain to
Master Mode
through the unit’s menu system.
Step 2. Set all other connected units to
Slave Mode
.
Step 3. The master unit can be controlled via DMX512, RDM or through standalone operation (self-contained
network utilizing on-board effects). The slave units will mimic the master unit’s operation in all cases.
Note:
For more information on DMX512 networking and systems, refer to
"Additional Resources for DMX512" on
. For SL NITRO 510C LED STROBE Luminaire DMX Mapping, refer to
Figure 15: SL NITRO 510C LED STROBE Luminaire - Master / Slave Configuration
DMX512
(out from
second to next luminaire)
DMX512
(in - from a
DMX controller)
Optional:
Master Unit
Slave Unit
Slave Unit
DMX512
(out from first
to second luminaire)
SL NITRO 510C LED STROBE
Luminaires
Summary of Contents for SL NITRO 510C
Page 1: ...SL NITRO 510C RGB W LED Strobe Luminaire ...
Page 56: ......
