8
Ordercode: 925000
Venga 15, 15” Plastic Active Speaker USB
Installation
Remove all packing materials from the Venga 15. Check that all foam and plastic padding is removed.
Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. The power supply is printed on the back of the device.
Do not attempt to operate an 115V specification product on 230V power, or vice versa.
Connection
01)
Press the power switch (20) to turn off the device.
02)
Connect the Venga to the other devices which you plan to use.
CAUTION: Make sure that the power is off, when connecting the cables.
AC Power
01)
Make sure the power switch (20) is in off position.
02)
Connect the power cable.
03)
Press the power switch (20) to turn the device on.
Stand-by Mode
01)
When the device is on, press and hold down the MODE button (11) for 2 seconds. The device will
enter stand-by mode.
02)
Repeat step 1 to switch the device on again.
Control Modes
1. Tuner Mode
01)
Press the MODE button (11) until the display shows FM.
Auto Tuning
01)
Press and hold down the
button for 3 seconds. The device will initiate auto tuning, which will stop
every time a strong radio signal is found and stored.
02)
It is also possible to stop auto tuning manually. In order to do so, press the
button.
Tuning
01)
Press and hold down the
or
button for 3 seconds. The device will initiate a backward or
forward tuning and will stop every time a strong radio signal is found.
02)
To manually stop tuning, press the
button.
Selecting Radio Stations
While in Tuner mode, press the
and
buttons to toggle through the programmed radio stations.
