Shoprider GK4, User Manual

Page: 11 / 19

10
DRIVE/FREEWHEEL OPERATION (FIG 5)
The drive/freewheel lever (yellow lever) is located at the right rear of unit. This lever allows
you to disengage the drive mechanism and push the scooter while in freewheel mode. To
disengage the drive mechanism (neutral), push the lever up (the scooter can now be pushed),
push the lever down (now the unit may be driven).
NOTE: The scooter will not operate while the drive/freewheel lever is in the neutral position
(forward). The scooter must be turned off, lever pushed downward (drive position) and then
turned on in order to reset the circuits.
WARNING! Always re-engage the free-wheeling device after use. Failure to do so may
result in injury.
Anti-Tip Wheels
The Anti-Tip Wheels are located at the rear of the scooter (Fig 5). The scooter should not be
used unless the anti-tip wheels are in place.
Shoprider ® is not responsible for damage or injury incurred due to improper or misuse of
the scooter.
Anti-Tip Wheels
Scooter in
Manual Mode
Scooter in
Drive Mode
Figure 5