-20-
Model W1842 (For Machines Mfd. Since 6/17)
SE
TU
P
Recommended.CFM.at.Dust.Port:................. 400.CFM
Dust.Collection
Tools.Needed.
Qty
Dust Collection System ........................................1
Dust Hose 4" .....................................................1
Hose Clamps 4" ..................................................2
To.connect.a.dust.collection.hose,.do.these.steps:
1.
Fit a 4" dust hose over the dust port, as shown in
Figure.16
, and secure it in place with a hose clamp.
2.
Tug the hose to make sure it does not come off.
Note:
A tight fit is necessary for proper
performance.
Do not confuse this CFM recommendation with the rating
of the dust collector. To determine the CFM at the dust
port, you must consider these variables: (1) CFM rating of
the dust collector, (2) hose type and length between the
dust collector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines throughout
the system. Explaining how to calculate these variables
is beyond the scope of this manual. Consult an expert or
purchase a good dust collection “how-to” book.
Figure.
16.
.
Dust hose attached to dust
port.
Dust
Hose
Dust
Hood
Hose
Clamp
This. machine. creates. substantial.
amounts. of. dust. during. operation..
Breathing. airborne. dust. on. a. regular.
basis. can. result. in. permanent. respira-
tory.illness..Reduce.your.risk.by.wear-
ing.a.respirator.and.capturing.the.dust.
with.a.dust.collection.system.
Summary of Contents for W1842
Page 65: ...Model W1842 For Machines Mfd Since 6 17...
Page 68: ......
