SHINKO-4/5 ton High Efficiency A5 Duct Technical Manual
25
1.
Notes
WARNING:
Failure to observe a warning may result in death.
Be sure only trained and qualified service personnel to install, repair or service the equipment.
Improper installation, repair and maintenance may result in electric shocks, short-circuit, leaks, fire or
other damage to the equipment.
Install according to this manual strictly. If installation is defective, it will cause water leakage,
electrical shock fire.
When installing the unit in a small room, take measure to against refrigerant from exceeding
allowable safety limits in the event of refrigerant leakage. Contact the place of purchase for more
information. Excessive refrigerant in a closed ambient can lead to oxygen deficiency.
Use the attached accessories parts and specified parts for installation. Otherwise, it will cause the
unit fall, water leakage, electrical shock fire.
Install at a strong and firm location which is able
to withstand the set’s weight. If the strength if not
enough or installation is not properly done, the unit will drop to cause injury.
The unit must be installed 2.5 meter above floor.
The unit shall not be installed in the laundry.
Before obtaining access to terminals, all supply circuits must be disconnected.
The unit must be positioned so that the plug is accessible.
The enclosure of the unit shall be market by word, or by symbols, with the direction of the refrigerant
flow.
For electrical work, follow the local national wiring standard, regulation and this manual. An
independent circuit and single outlet must be used. If electrical circuit capacity is not enough or
defect in electrical work, it will cause electrical shock fire.
Use the specified wire, connect it tightly and clamp it so that no external force will be acted on the
terminal. If connection or fixing is not perfect, will cause heat-up or fire at the connection.
Wiring routing must be properly arranged so that control board cover is fixed properly. If control board
cover is not fixed perfectly, it will cause heat-up at connection point of the terminal, fire or electrical
shock.
If the power wire is damaged, it must be replaced by the manufacture or its service agent or similarly