Shining 3D EinScan-SP, User Manual

Page: 22 / 46

21
Click ‘Calibrate’ to enter the interface of calibrate. If there is no calibration data, choose
device type and it will enter the calibration interface automatically.
The interface of calibrate:
Calibrating your scanner is important in order to get accurate scan results. The
following describes the three steps required to successfully calibrate your device.
Follow the software operation guide, adjust the distance between the projector and
calibration board, and the cross from scanner should target at the calibration board n clearly.
Place the calibration support and board in the center of the turntable as shown in Figure A.
Check that the calibration board is located at the center of the turntable with the Figure A
pattern facing the scanner and click “Snap”. Do not interfere or touch the calibration board during
the calibration sequence.
Calibration