AccuFab-L4D & L4K_User Manual_V3.2.20_June 2021
31
5.
Process Model
5.1.
Take Out Model
Note:
For appearance, AccuFab-L4D and AccuFab-L4K differ only in sunshield colors. This chapter takes AccuFab-L4K
as an example.
Step 1 After the model printing finishes, lift and suspend the build platform for 5 minutes. Thus, the residual
resin material attached to the model
’s
surface drops back to the resin tank.
Step 2 Use silicon scraper provided in accessories to scrap off the resin material on the build platform obliquely.
Release the tongue depressor, take out the build platform, and place the platform sideways on the bench.
Step 3 Select "Flat Pry Knife" in the accessories list to take the printed model from the platform. Mind that flat
pry knife direction cannot be towards any human body part.
