Shindaiwa DGK180F, Owner'S And Operator'S Manual, Page: 14 / 66

11
5-1. Three-phase and Single-phase simultaneous Output
This generator is capable of generating three-phase and single-phase three-wire output
simultaneously. (Three-phase output terminal and single-phase three-wire output terminal are
equipped individually.)
Neither switching operation of output nor switching operation of wiring is needed.
Three-Phase and Single-Phase Three-Wire Output Terminal
< Note >

Refer to section
“
7-2. Connecting Load Cables
” for Load Connections.

If using three-phase output simultaneously with a single-phase three-wire type output, use in
a range where the total current does not exceed the rated current.
5-2. Available Output Monitor
The available generated output for each output power source is displayed digitally.
< Note >

Consider the digitally displayed available output as an
approximate estimate. Be sure to thoroughly consider the
displayed value and the used load capacity when using a load
such as a motor with large starting capacity.

The displayed output capacity might not be correct values if
using a four-wire connection (single-phase using the N
terminal) for a three-phase output power source. Connect to a
single-phase/three-line type power source if using a
single-phase power source.
 If “- -” is displayed for the available output, it means that usage
has exceeded the rated capacity. Immediately stop the
equipment being used and reduce the load capacity of the
equipment.
5. Equipment
U W
L1 L2 L3 N GROUND