Shindaiwa DGK14F, Owner'S And Operator'S Manual, Page: 19 / 50

16
5-6. Fuel Piping Switch (3Way Fuel Valve)
CAUTION:

Always make sure that the engine is stopped when working on piping.

Always be sure to wipe up any spilled fuel.

After working on the piping, check that there is no fuel leakage.
Change the three-way fuel valve to switch to supply fuel from the external tank. In that case,
the internal fuel tank is not used.
(1) If using the internal fuel tank
Change the lever of the three-way fuel valve turned
to the “A” side to supply fuel from the
internal tank. It
is turned to the “A” side when the generator is shipped from the factory.
< Note >
 When disconnecting piping from the external tank, turn the lever to the “A” side, and attach the
bundled plug(R1/2
”) to the external tank fuel inlet/return.
(2) If using an external fuel tank
Connect hoses from the external fuel tank to the external fuel inlet and the external fuel
return
. Change the lever of the 3way fuel valve to the “B” side to supply fuel from the
external tank.
Refer to “
9-5. Connecting with External Fuel Tank
” for corresponding procedures.
6. Transport/Installtion
6-1. Transport Procedures
WARNING : INJURY

Do not lift up the unit using tie down. Use of such could result in the generator falling.

No persons should ever be under a lifted generator.
CAUTION : INJURY

Always be sure to use lifting hooks when lifting up the generator, and raise it
slowly at a completely vertical angle.

Personnel performing lifting work must wear protective gears such as helmets,
safety shoes and gloves.

Do not move the generator during operation.
Position B Position A
External Fuel
Return
External Fuel
Inlet
3Way Fuel
Valve