
Operation Procedures
INSTRUCTION MANUAL FOR 5
”
DISC GRINDERS
1.Connect the coupler to the air inlet
❶
on the rear side of tool.
2.Make sure the disc cover
❷
is firmly mounted in place. Make
sure the diameters of the grinding stone and the hole are suit
each tool.
Adjustable disc cover can be moved with turning to right/left.
Before use, make sure the adjustable disc cover is firmly
locked to the tool in position.
3.Pour approx. 0.5cc (2 to 3 drops) of the oil through the coupler.
Connect it to the air hose, and run for 3 to 5 seconds to
circulate the oil.
4.When the grinding stone is installed, press the spindle lock
button
❸
at the angle head, and the spindle will stop. Turn it
counterclockwise with the pin spanner, and firmly tighten the
spindle.
Accessories : 5” Disc (1), Pin spanner (1),
Hex. wrench (1),
Safety instructions (1)
Max. rpm:12,000rpm
Grinding stone size :
125
φ
mm x hole 22
φ
mm
❶
Air inlet
❹
Safety lever
❸
Spindle lock button
❷
Disc cover
Push
Hex. wrench
Hole size
Cap screw
Disc receiver
Grinding stone dia.
Disc receiver
Disc nut
Spindle
Pin spanner
Accessories : 5” Disc (1), Pin spanner (1),
Hex. wrench (1),
Safety instructions (1)
Max. rpm:12,000rpm
Grinding stone size :
125
φ
mm x hole 22
φ
mm
❶
Air inlet
❹
Safety lever
❸
Spindle lock button
❷
Disc cover
①
②
③
Cap screw
Disc nut
Disc nut
Disc nut
Hole size
Cap screw
Disc receiver
Grinding stone dia.
Washer
Spindle lock button
Lock lever
Lock lever
Ajustable disc cover
Push
Hex. wrench
Disc receiver
Disc nut
Spindle
Pin spanner
①
②
③
Cap screw
Disc nut
Spindle lock button
270°
105°