MY22H03 - 22_1.0_01.10.2021
98
Operation
6.5.11.3 Adjusting the ROCKSHOX fork coil spring with spacer for pre-tensioning
Only applies to pedelecs with this equipment
1
Put on normal cycling clothing (including
baggage).
2
Ask someone to hold the bicycle.
3
Stand on the pedals. Allow the damper to
deflect three times. Sit or stand on the pedelec
in a normal riding position.
4
Ask your helper to push the O-ring downwards
until it reaches the top of the dust wiper seal.
Figure 104: Moving the O-ring on the suspension fork
5
Get off the pedelec without allowing it to
deflect.
6
Note distance between dust wiper and the O-
ring. This distance is the sag.
Figure 105: Sag (1)
7
Check the sag.
8
If the desired sag is not achieved, the spring
preload must be adjusted internally and/or the
coil spring replaced. Contact specialist dealer.
1
Setting
Sag
Prohibited
>30%
High sensitivity
20–30%
Low sensitivity
10–20%
Prohibited
<10
Table 41: Recommended sag
Figure 106: Mandatory sag range (green) and prohibited
sag range (red)
