51
13. Enhancing Productivity
Read Chapter 7 Before Use of
These Pages
13.6 Taring/Printing at Stability
Determine if the balance should wait for stability before printing when the
[PRINT]
key is pressed or
displaying the zero point when the
[O/T]
key is pressed.
To print or tare without waiting for stability
: (Immediately mode)
Select menu item
.
To have printing or taring take place after the stability is detected
: (Waiting for stabilization)
Select menu item
.
Note
When a Pretare value is set, the value to determine that there is “no load”
becomes
“- Pretare
±
Zero Range” during gram-display. The Zero Range
function works as expected when attempting to weigh and Auto Print the
mass of a bottled sample during gram-display.
Notes
While the balance is waiting for stabilization, ---- is displayed.
• When the
[O/T]
key has been pressed,
“---” is displayed. At this occasion, press the
[POWER]
key if you desire
to disable this function and abort taring.
• When the
[PRINT]
key has been pressed,
Once the communication symbol and the Stand-by symbol are lit, then
stability mark is waited. The data will be output after the stability mark is
lit. If the
[POWER]
key is pressed during the waiting, the balance is
brought to stand-by. The data will be printed upon stability in the next
weighing.
39
40