Analog input and output parameter group 02
PARAMETER DESCRIPTION 121
5.3.2
Analog output terminals AM function selection
Selects the monitor item for analog output terminal AM1 AM2.
Parameter
Name
Default Setting Range
Content
02-04
P.54
Terminal AM1 output
function
0
0
Output frequency, use 02-51 (P.55) value as 100%.
1
Output current, use 02-52 (P.56) value as 100%.
2
Output DC bus voltage, use the
OV trigger voltage as 100%.
3
Output inverter temperature accumulate rising rate, use NTC
trigger level as 100%.
4
Output inverter thermal relay accumulate rate, use the digital
thermal relay trigger level ( 06-00 ( P.9 ) ≠ 0 ) or the thermal
relay on IGBT trigger level ( 06-00 (P.9) = 0) as 100%.
5
Target frequency, use 02-51(P.55) value as 100%.
6
Fixed output, voltage or current output level can be set by
02-54 (P.541)
7
Output voltage, use inverter rated voltage as 100%
8
Excitation current, use motor rated current as 100%. (Valid
only when 00-21(P.300) or 00-22 (P.370) is set to 3~6)
9
Output torque, use two times motor rated torque as
100%.(Valid only when 00-21 (P.300) or 00-22 (P.370) is set
to 3~6)
10
Output power, use two times motor rated power as 100%.
11
High-speed pulse input, use 100KHz as 100%.
12
Motor speed, use 02-51 (P.55) as 100%
13
PLC analog output, for details please refer to SA3 built-in
PLC manual
02-05
P.537
Terminal AM2 output
function
0
0～13
Fixed output, voltage or current output level can be set by
02-53(P.539).
0~5, 7~13: Same as 02-04(P.54).
Usage of analog output terminal AM
For the voltage/current calibration of terminal AM, please refer to calibration parameter in section 5.3.11 output
terminal AM1 signal selection and processing.
Setting
